Garage Door Cable Repair
A loose or frayed cable can let one side of the door drop, so leave it closed while we replace the pair and level the door.
A garage door lift cable fails when its strands corrode and fray or when it slips off the cable drum, and the door then hangs from one side or will not rise. On a torsion door, a cable runs from each bottom bracket up to a grooved drum on the shaft; as the door opens the drum winds the cable and the spring torque lifts the door. Each cable carries about half of the lifting load, so one failing cable puts the strain of the whole door on the other.
We replace both cables, not just the visible casualty, because they have worked the same cycles. We inspect the drums for worn grooves, the bottom brackets and any cable safety device, cut the new cables so both sides carry equal tension, and tighten the drum set screws against the shaft. A cable that goes slack can disengage from the drum, which is how many of them end up on the floor, so we look for the cause of the slack as well as the break.
Signs You Need Garage Door Cable Repair
- A frayed or unwound strand near the bottom bracket
- The door hangs low on one side and rises crooked
- A cable dangling at a bottom corner
- The door jams a few inches up and the opener strains
- A lift cable sitting beside its drum instead of in the grooves
- A loud pop, then one side of the door drops
⛈️ The Middle Tennessee Storm Factor
Damp air and winter slush are what age cables here. Lift cable that sits in a humid garage corrodes first where it bends over the drum and at the bottom bracket, where meltwater collects on a closed door; the Nashville airport station records about 66 freezing nights a year, so slush and meltwater at the floor edge are part of most winters. DASMA's terminology sheet describes the bottom bracket as the support that holds the roller and may carry the lifting cable, which is why we check that corner for rust on every cable job. Wind is the other factor, with about 22 severe-storm wind reports a year in Davidson County: a door that bounces in its tracks can slacken its cables.
How We Handle It
Release the load
The door is secured and the spring tension is dealt with before any cable is touched.
Read the failure
Fray point, drum grooves, bottom brackets and rollers show why the cable failed.
Replace both sides
Matched cables are cut to length, seated in the drums and set so both sides carry the same tension.
Cycle and confirm
The door is raised and lowered by hand, then under the opener, and must rise level.
Garage Door Cable Repair — FAQs
What makes a lift cable keep slipping off its drum?
A cable leaves the drum when it goes slack, which happens if the door catches on a bent track or a stuck roller, if the cable has stretched, or if the drum is damaged. DASMA warns that slack cables can disengage and cause uncontrolled door movement, so the cause needs fixing along with the cable.
Can I use my garage door with one cable broken?
No, a garage door should not be used with one cable broken. With one cable gone, the other carries the whole lift, the door tilts, and it can bind in the tracks or fall. Leave the door where it is and keep people clear.
When only one cable is frayed, should both be changed?
Yes, both garage door cables should be replaced at once. Both cables have been through the same trips in the same garage, so the second one is usually near the end of its life, and replacing both lets us set equal tension on each side.
Is a frayed garage door cable dangerous?
Yes, a frayed garage door cable is dangerous. A cable under spring tension can snap and let the door drop or whip free. DASMA tells occupants not to touch springs, cables or the brackets they are attached to, so stay clear and call a technician.
Garage Door Cable Repair in Brentwood and Nearby Towns
Brentwood, TN
Garage Door Cable Repair in Brentwood →Franklin, TN
Garage Door Cable Repair in Franklin →Nolensville, TN
Garage Door Cable Repair in Nolensville →Green Hills, TN
Garage Door Cable Repair in Green Hills →Forest Hills, TN
Garage Door Cable Repair in Forest Hills →Oak Hill, TN
Garage Door Cable Repair in Oak Hill →Thompson's Station, TN
Garage Door Cable Repair in Thompson's Station →Berry Hill, TN
Garage Door Cable Repair in Berry Hill →Old Hickory Boulevard office, Brentwood
Book a garage door repair
Tell us the symptom in plain words (a spring that snapped, a door hanging crooked, a remote that quit) along with your street and town. The arrival window is agreed on the call, and the price is confirmed with you on site before the first part comes off.
Where to find us
- Address: 750 Old Hickory Blvd Bldg 2, Suite 150, Brentwood, TN 37027
- Phone: (615) 437-7061
- Hours: Open 7 AM to 10 PM, all seven days
- Open our Brentwood office in Google Maps
Get a free estimatePhone the team
Directions, email and the longer form are on the Parthenon contact page, and every repair we handle is described in the services overview.
Prices to start from
| Garage Door Spring Replacement | from $150 per spring |
|---|---|
| Garage Door Cable Replacement | from $150 per cable |
| Roller Replacement | from $120 per set |
| Track Repair & Off-Track Door | from $150 per door |
| Garage Door Opener Repair | quoted on site after we check the brand and model |
| Panel Replacement | quoted on site after we match the model and color |
| Diagnostic Service Call | $0 with a completed repair |
Each figure is where a job of that kind begins. Spring size, door weight and the parts your door needs set the final number, and we tell you that number before any work begins.
Photos of garage door work


