Brentwood, TN · Phones answered 7 AM to 10 PMCall: (615) 437-7061

Garage Door Opener Installation

We check the springs and the balance before the new opener goes up, then set the travel, force and safety eyes and pair your remotes.

A new garage door opener should go onto a door that is already balanced, because an opener cannot do the springs' job, and DASMA warns that an unbalanced door may not reverse when it should. Installation therefore starts with the same hand-lift test as a repair, and any worn spring, roller or cable is dealt with before the new motor is mounted.

Then we match the opener type to the opening. A trolley opener with a rail suits most ceilings with normal headroom. A wall-mounted jackshaft opener turns the torsion shaft and frees the ceiling, but on a standard-lift track it needs added provisions to keep the cables tight, so we check the door and the opener maker's instructions before recommending one.

We mount the header bracket, rail and door reinforcement, set the photo-eye beam six inches or less off the floor, adjust the travel and force limits, and test the reversal with a 2x4 laid flat before we go. Battery backup, keypads and phone control can be added, and we explain which ones the unit supports.

Signs You Need Garage Door Opener Installation

  • An opener loud enough to hear upstairs
  • A chain drive that rattles and jerks at the start
  • No battery backup, so a dead door in every outage
  • Remotes that will not pair or have no range
  • An older unit with no photo-eye pair at the floor
  • A ceiling too crowded for a rail

⛈️ The Middle Tennessee Storm Factor

Power outages are the regional reason people ask for battery backup. Davidson County's hazard plan notes a January 2013 ice storm and the February 2015 winter storm that left thousands of Tennessee customers without power for several days, and thunderstorm wind reports run about 22 a year. DASMA says that in outage-prone areas an opener with battery backup is a convenient way to get the door open, that the backup should be tested periodically, and that its battery needs replacing after two to five years. We also point out the red manual-release handle, which should hang about six feet above the floor, so the household knows how to open the door without power.

How We Handle It

Step 1

Balance first

The old opener is disconnected and the door lifted by hand; springs, cables and rollers are corrected before a new motor goes on.

Step 2

Choose the drive

Trolley, belt or wall-mount, picked for the ceiling, the track type and how quiet the room above needs it.

Step 3

Install and align

Header bracket, rail, reinforcement, photo-eyes within six inches of the floor, and a wall control in clear view of the door.

Step 4

Set limits and test

Travel and force are set against the door, then reversal is tested with a 2x4 and the beam.

Garage Door Opener Installation — FAQs

Do I need new springs when I install a new garage door opener?

A new opener does not always need new springs, but the door must be balanced first. If the door will not hold at three to four feet off the floor with the old opener disconnected, the springs or cables get corrected, because a new opener cannot make up for an unbalanced door.

Which suits our garage better, a belt-drive or a chain-drive opener?

Belt drives are generally the quietest, which helps when someone sleeps or lives in the room over the garage. Chain drives are the traditional choice and usually cost less, and a wall-mounted jackshaft opener keeps the ceiling clear. We match the type to your garage.

Do new garage door openers need photo-eye sensors?

Yes, a new garage door opener needs a secondary reversing system, usually photo-eye sensors. Federal rule 16 CFR 1211 requires primary reversing protection plus a secondary system, usually photoelectric eyes, and DASMA's installation sheet puts the beam no higher than six inches above the floor. We install both and test them before leaving.

Is battery backup worth adding to a new garage door opener?

Battery backup is worth it where outages are common. DASMA says it gives a convenient way to open the door without power, that the battery should be tested periodically, and that it needs replacing after two to five years depending on use.

Can any opener be installed on any garage door?

No, an opener cannot be installed on just any garage door. The door has to be balanced, and a jackshaft opener on standard-lift track needs extra provisions to keep the cables taut, according to DASMA. Low-headroom track needs approval from both the door and the opener makers.

Old Hickory Boulevard office, Brentwood

Book a garage door repair

Tell us the symptom in plain words (a spring that snapped, a door hanging crooked, a remote that quit) along with your street and town. The arrival window is agreed on the call, and the price is confirmed with you on site before the first part comes off.

Where to find us

Get a free estimatePhone the team

Directions, email and the longer form are on the Parthenon contact page, and every repair we handle is described in the services overview.

Prices to start from

Garage Door Spring Replacementfrom $150 per spring
Garage Door Cable Replacementfrom $150 per cable
Roller Replacementfrom $120 per set
Track Repair & Off-Track Doorfrom $150 per door
Garage Door Opener Repairquoted on site after we check the brand and model
Panel Replacementquoted on site after we match the model and color
Diagnostic Service Call$0 with a completed repair

Each figure is where a job of that kind begins. Spring size, door weight and the parts your door needs set the final number, and we tell you that number before any work begins.

Photos of garage door work

Hands tightening a hinge bolt on a white steel garage door section
Installer securing a track bracket next to a white windowed garage door
Installer on a stepladder adjusting the opener rail over a white windowed door
☎