Brentwood, TN · Phones answered 7 AM to 10 PMCall: (615) 437-7061

Garage Door Panel Replacement

If the maker still builds your door, one damaged section can be swapped without buying a whole new door; we confirm the model and color first.

A damaged garage door section can usually be replaced on its own, as long as the same door model is still made and the neighboring sections, tracks and frame are sound. The sections are hinged together and stiffened by struts, so a section that has creased or cracked loses its stiffness, and the whole door can bow, bind in the tracks or let a roller slip out of its guide.

We start by sorting cosmetic damage from structural damage: creases across the stiles, cracks at hinge points, separation in the section's skin. DASMA says any deformation of panels, tracks or hardware makes a door questionable to operate, so we do not cycle a creased door under the opener. If the maker's section is available in the same size, profile, insulation and color, we fit it and move the hardware across. On a wind-rated door we stay with the maker's parts, because DASMA warns that look-alike parts can weaken the assembly.

A new section weighs what the old one did, but anything added shifts the balance, so we recheck the springs afterward. If the style is discontinued, a new door may be the honest answer, and we will say so.

Signs You Need Garage Door Panel Replacement

  • A dent or crease that runs across a section
  • A crack beside a hinge or at a roller bracket
  • A section bowing outward while the rest looks flat
  • Visible gaps between sections when the door is closed
  • The door binds or rubs after a car bumped it
  • Dimples and pockmarks across the face after a hailstorm

⛈️ The Middle Tennessee Storm Factor

Hail is what sends most panel calls here. Davidson County's hazard plan says hail falls several times a year and reports the largest stone in its 2011 to 2016 data at 1.75 inches. In our experience thin steel skins dent and insulated sections crease at the stiles, so a spring storm can leave a whole street of doors needing the same section. We photograph the damage and mark which parts are cosmetic and which are structural, which is what a repair estimate or a later inspection will want to see.

How We Handle It

Step 1

Sort the damage

Cosmetic or structural: creases, cracks, hinge points and separation checked with the door closed.

Step 2

Match the section

Same maker, size, profile, insulation and color, or a straight answer that none exists.

Step 3

Swap and reinforce

The section is replaced, hinges and struts moved or renewed, and neighboring sections checked for square.

Step 4

Rebalance and test

Springs are rechecked for the new section's weight and the door is run through full cycles.

Garage Door Panel Replacement — FAQs

Can you replace one panel on a garage door?

Often a single garage door panel can be replaced, if the door maker still produces the section in that size, style and color, and the other sections and tracks are undamaged. When the model is discontinued or several sections are creased, replacing the whole door is the better repair.

Will a replacement garage door section match the color of my door?

Only if the finish is still made, and sun fade can leave even a correct color looking newer than the rest of the door. We show the section against the door before ordering.

Is a dented garage door safe to use?

A dented garage door is not safe to use until it has been checked. A crease across a section weakens it, and DASMA says any deformation of panels, tracks or hardware makes a door questionable to operate, so it should not be cycled until a technician has looked.

Does hail damage on a garage door mean replacement or repair?

Hail damage is repaired or replaced depending on how much of the door is hurt. Dents confined to one section are repaired by replacing that section, but creased stiles across several sections, or a discontinued model, point to a new door.

Can one damaged section make a garage door fall?

A damaged section can make a garage door fall. A cracked section may let a hinge pull out or a roller slip, and then the door hangs on fewer points. If a section is cracked near a hinge, keep the door closed and call for repair.

Old Hickory Boulevard office, Brentwood

Book a garage door repair

Tell us the symptom in plain words (a spring that snapped, a door hanging crooked, a remote that quit) along with your street and town. The arrival window is agreed on the call, and the price is confirmed with you on site before the first part comes off.

Where to find us

Get a free estimatePhone the team

Directions, email and the longer form are on the Parthenon contact page, and every repair we handle is described in the services overview.

Prices to start from

Garage Door Spring Replacementfrom $150 per spring
Garage Door Cable Replacementfrom $150 per cable
Roller Replacementfrom $120 per set
Track Repair & Off-Track Doorfrom $150 per door
Garage Door Opener Repairquoted on site after we check the brand and model
Panel Replacementquoted on site after we match the model and color
Diagnostic Service Call$0 with a completed repair

Each figure is where a job of that kind begins. Spring size, door weight and the parts your door needs set the final number, and we tell you that number before any work begins.

Photos of garage door work

Two installers on ladders fitting the left and right tracks of a white door
Stacks of new garage door sections and track parts in a supply warehouse
Installer on a ladder reaching the upright track of a white garage door
☎